Montigo L-Series DF Guía de instalación descargar pdf (Pagina 3)

Page 3

L52-DF Gas Fireplace

Part No. XG0180

f i r e f e a t u r e

Installation

Installing The Fireplace Shell

The replace may be installed in any location that maintains proper clear-

ances to air conditioning ducts, electrical wiring and plumbing. Safety,

as well as efciency of operation, must be considered when selecting

the replace location. Try to select a location that does not interfere

with room trafc, has adequate ventilation, and offers an accessible

pathway for Direct Vent installation. Refer to page 4 - Vent Installation

for more information.

The replace dimensions are shown below:

When installing a shelf over the top of the fireplace, the

foll o wing gui d elines m u st be adhe r e d to: For Top

Vent applications, the minimum clearance is 24". (Minimum

2" clearance must still be maintained around the vent pipes.)

Figure 4. Framing for shelves over the ﬁreplace.

Top Vent

Figure 3. Minimum Corner framing dimensions, using a 45° elbow.

Figure 2. Framing dimensions.

* When sheetrock is

not used behind the

ﬁreplace, framing

depth may be reduced

by 5/8"

Framing

WARNING:

When this appliance is installed directly on carpeting, tile or

any combustible material other than wood ooring, it must be

installed on a metal or wood panel extending the full width and

depth of the appliance.

* Clearance from the top of the replace to a combustible ceiling within the replace

enclosure

** Refer to the 'Finishing around the replace' section of this manual.

Unprotected combustible walls which are perpendicular to the replace

opening, must not project beyond the shaded area shown in Figure

24.

For protection against freezing temperatures, it is recommended that

outer walls of the chase be insulated with a vapor barrier. This will reduce

the possibility of a cold-air convection current on the replace.

Clearances

These clearances apply to all dimensions except the framed opening,

where the clearances to combustibles is 0". The L52-DF clearances to

combustible materials are:

Top - Rear Vent *

N/A

Top - Top Vent

Back

Sides

Floor

Mantle**

25”

52”

39 1/2”

Top View

Front View

Side View

0" clearance

to corners only

96 1/2”

52”

68 1/4”

47”

2 1/2”

52”

6 3/4”

5 1/4”

1”

21 1/4”

2 1/2”

33 1/4”

22 1/2”

28”

33 1/4”

52”

47 1/4”

13 1/2”

22 1/2

”

Header

PE L Short

Shelf

39 1/2

1 2 3 4 5 6 7 8 ... 21 22

Comentarios a estos manuales

Sin comentarios

Montigo L-Series DF Guía de instalación Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para Chimeneas Montigo L-Series DF