Montigo EDVRSPV47 Manual de usuario descargar pdf (Pagina 3)

EDVRSPV Vertical Power Vent System

Part No. XG1302 - 120110

f i r e f e a t u r e

CAUTION!

Due to its high operating temperatures, the appliance

should be located in a well ventilated area / space. See

the clearancespecications on Page 8.

 Children and adults should be alerted to the hazards

of the high surface temperature, which could cause

burns or clothing ignition.

 Young children should be carefully supervised when

they are in the same room as the appliance.

 Clothing or other ammable materials should not be

placed on or near the appliance.

Introduction

Before You Begin

■ Minimum clearances 1” from vent to all combustible materials

must be maintained. Clearances listed in the replace’s Instal-

lation Operation and Maintenance Instructions supersede this

number.

CAUTION:

Ensure Perforated Air Holes in the New Pipe Adapter / Restrictor

are not Covered when installing New Pipe Connection.

CAUTION:

When cold air enters the warmer building interior, primarily at the

air intake end, condensation may occur on the exterior of the ex

pipe. To limit this condensation, install insulation over the last

twenty feet of ex pipe. Also, by sloping the last 20'-0" feet of ex

pipe downward toward the exterior of the building, elimination of

most of the condensation problems should occur. Ensure the ter-

mination is securely fastened, and sealed to the ex pipe. Fasten

the termination to exterior of the building with water tight sealant

and the appropriate fasteners.

General Information

This installation guide covers installation of the External Power Vent

System only. This system is designed to allow installation of gas re-

places that cannot be done with a standard Direct Vent gas replace

installation.

Also, read through the replace's Installation Operation and Mainte-

nance Instructions, as it must also be adhered to.

Power Cord Harnesses:

EPVH10 -10 foot power cord and harness

EPVH20 -20 foot power cord and harness

EPVH30 -30 foot power cord and harness

EPVH40 -40 foot power cord and harness

EPVH50 -50 foot power cord and harness

EPVH60 -60 foot power cord and harness

EPVH70 -70 foot power cord and harness

EPVH80 -80 foot power cord and harness

EPVH90 -90 foot power cord and harness

EPVH100 -100 foot power cord and harness

Selecting and Installing the

Fireplace

When selecting a gas replace for use with the External Power Vent

System, take into consideration the various requirements and limita-

tions in the venting installation section for the following models:

Models Equipped with Hot Surface Ignition (HSI)

It is recommended that this system be used with a gas replace

equipped with a Hot Surface Ignition System. Because there is not a

pilot in this system, there is more exibilty on venting requirements.

For example downward vertical vet runs are possible with an HSI

system, as outlined in the Venting Section.

Models Equipped with Millivolt/ Standing Pilot

If a standing pilot model must be used, then the millivot wiring har-

ness must be installed, see the Wiring Section for more information.

Also, downward vertical vet runs are not possible with a standing pilot

system, as outlined in the Venting Section.

Installation

Page 3

1 2 3 4 5 6 7 8 ... 11 12

Comentarios a estos manuales

Sin comentarios

Montigo EDVRSPV47 Manual de usuario Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para Para Casa Montigo EDVRSPV47