Montigo L-Series DF-ST Guía de instalación descargar pdf (Pagina 11)

Page 11

L-Series DF-ST See-thru Gas Fireplace

Part No. XG0812

f i r e f e a t u r e

Installation

Figure 18. Reducing Vertical Vent from 5/8" to 4/7".

Reduced Vertical Installation

It is possible to reduce vertical vent runs from 5"/8" venting to 4"/7"

venting. Reduced vertical venting may only be used when the installation

exceeds 12 feet and terminates through the roof, and if the vertical vent

reducer is used with the following venting conguration.

Finishing Around the Fireplace

Combustible mantels and mouldings may be safely installed over the

top and on the front of the replace provided that they do not project

beyond shaded area shown in Figure 24. Side wall clearances are 3".

Combustible surrounds may be installed with 3" clearance to the side

of the replace as shown in Figure 25.

Fireplace Facing

When selecting the nish material for your replace, it is important to

remember the following: THE HORIZONTAL LOUVRES MUST NOT

BE OBSTRUCTED IN ANY WAY - to do so restricts the air supply

for the control compartments and heat exchanger it also prevents

access for servicing controls.

The face of the replace may be painted to match the room decor,

provided you use a heat-resistant paint. Decorative facing must not

extend past the replace opening at all, because it will interfere with

the access to retainers for removal of glass door.

Figure 24. Combustible mantles and facings.

Horizontal Run (in)

Non-Combustible

Facing Material

on-Combustible

acing Material

Non-combustible Header

(Supplied by Montigo)

Drywa

/ S

eetroc

6”

”

Mantels & Surrounds

NOTE: National Canadian Gas Association mantel test requirements

are for re hazard prevention to combustible materials.

New technology, to meet consumer and government demands for the

wise use of energy, has prompted us to manufacture many models of

replaces which are hot, fuel and energy efcient.

Please be aware; temperatures over the mantel will rise above normal

room temperature and walls above replace may be hot to touch.

Warning:

When covering the upper metal portion of the replace with a non-

combustible material Please Note: The decorative facing materials

may be subject to temperatures in excess of 250° F. This should be

considered when selecting facing materials.

We recommend careful consideration be given to the effects of elevated

mantel temperatures which may be in excess of product design, for

example: candles, plastic or pictures. This can cause melting, deformation,

discoloration or premature failure of T.V. and radio components.

Painting:

Special care is recommended by the Master Painters and Decorators

Association, when painting the replace surrounds, to select and apply

a quality Alkyd sealer prior to the applying of latex paints. This is to

prevent leaching of water from evaporation and causing a brownish

staining effect to paint over coats.

Figure 25. Combustible surrounds, (Both Sides Typical).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Comentarios a estos manuales

Sin comentarios

Montigo L-Series DF-ST Guía de instalación Pagina 11

Comentarios a estos manuales

Relacionado con productos y manuales para Chimeneas Montigo L-Series DF-ST