Montigo L-Series DF-ST Guía de instalación descargar pdf (Pagina 3)

Page 3

L-Series DF-ST See-thru Gas Fireplace

Part No. XG0812

f i r e f e a t u r e

Installation

Installing The Fireplace Shell

The replace may be installed in any location that maintains proper clear-

ances to air conditioning ducts, electrical wiring and plumbing. Safety,

as well as efciency of operation, must be considered when selecting

the replace location. Try to select a location that does not interfere

with room trafc, has adequate ventilation, and offers an accessible

pathway for Direct Vent installation. Refer to page 4 - Vent Installation

for more information.

The replace dimensions are shown below:

When installing a shelf over the top of the fireplace, the

following guidelines must be adhered to: For Rear Vent

applications the minimum clearance from the top of the replace

to a shelf is 10" (L38) and 12" (L42). For Top Vent applications, the

minimum clearance are shown in the clearance table. (Minimum

2" clearance must still be maintained around the vent pipes.)

Figure 2. Framing dimensions.

Framing

WARNING:

When this appliance is installed directly on carpeting, tile or

any combustible material other than wood ooring, it must be

installed on a metal or wood panel extending the full width and

depth of the appliance.

Top View

Front View

Side View

Clearances

These clearances apply to all dimensions except the framed opening,

where the clearance to combustibles is 0". The L38DF-ST and L42DF-ST

clearance to unprotected combustible walls which are perpendicular to

the replace opening, must not project beyond the shaded area shown

in Fig. 24.

For protection against freezing temperatures, it is recommended that

outer walls of the chase be insulated with a vapor barrier. This will reduce

the possibility of a cold-air convection current on the replace.

Figure 1. Fireplace dimensions.

* Clearance from the top of the

to a combustible ceiling within the

enclosure.

** Refer to page 14.

5 1/2”

5 1/4”

A B C D E F G H I J K L

L38DF-ST

4 29

2 36

2 1

4 17

8 7 5 8 34

L42DF-ST

8 30

2 24 40

2 34

7 5 8

17 1/2"

Sides

Floor

Mantle

Top (Top Vent )

L38DF-ST

L42DF-ST

10"

Top (Rear Vent)

Back

3”

Annulus

17 1/2"

12"

3”

Notes:

Install supplied metal header

above ﬁreplace after unit is in

place. Use supplied hardware to

fasten to framing.

Both sides Typical. Unit may not

be exactly as shown.

L38DF-ST

Framing Dimensions

L42DF-ST

40 42

1 2 3 4 5 6 7 8 ... 21 22

Comentarios a estos manuales

Sin comentarios

Montigo L-Series DF-ST Guía de instalación Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para Chimeneas Montigo L-Series DF-ST